ancient cup project

 

This is an ancient Vessel from Ciempozuelos, beginning of the second millennium BC. It is a Bell Beaker cup, a style that has been found all over Europe and dates back millennia. They have been suggested to have been designed for the consumption of alcohol as bear and mead content have been found on some samples. They were also used as reduction pots for smelting copper ores, as food vessels, and as funerary urns. The process for making and firing the cups varies greatly as they have been found across

Genevieve Krass Historical Project

 

This piece is a decorated global vessel, with an everted lip, from an Igbo tribe in Africa. 

To make the vessel, the clay was mined and prepared, then mixed the clay with water until it was malleable. Matter (such as ground sand, pebbles, old pottery, or crushed dried grass) was mixed into the clay to decrease shrinkage during the drying and firing process. The substance mixed in never exceeded 50% of the mixture. Clay was coiled around a flattened base, then molded and smoothed into a shape. The piece was then sundried, decorated when fully dried, and then wood fires for four hours.

Test 3

 Test

Test 2

 Test 2

Test

 Test 

Historical Project

 Project 1 _ Post an image of your cup and any related technical information. 

You will recreate this cup as well as make a modernized version of it.

WILD CLAY | Part II - IMPROVED PROCESS

STEP 1: DIG UP SOME CLAY- You will find it everywhere. The photo above shows a nice piece of naturally occurring compact clay I found along a river bed. You can tell its clay and not a rock because your finger nail can scratch it.

STEP 2: LET THE CLAY DRY AND BREAK IT INTO POWER - Do this outside and wear a mask so you do not breath in dust. I used heavy plastic to contain the clay but you could also use an old t-shirt or pillow case.

STEP 3: SIEVE THE CLAY - I used a common kitchen sieve to remove any possible rocks or organic material.

STEP 4: YOUR CLAY SHOULD BE POWDER and then you can REHYDRATE it by slowly adding the powder to  water. Start with a small amount of water. You don't want to add too much water at this point just enough to allow the clay to be formed up a little and NOT a slurry.

STEP 5: Allow your clay to dry to a workable consistency. I will next use a coil building method to create some small vessels which will be fired in a primitive pit firing. No special equipment or tools to create ceramics in your back yard.